Controller / Automatic Contactless Water Level Sensor for Tank (XKC-C352-2P)

With this automatic water level controller you don't have to worry about the management of your tank, and you don't need to drill holes or modify it. The sensors read wirelessly if there is water (or any liquid) behind the wall of the tank at that exact point, simply stick a sensor at the maximum level and another at the minimum, the controller activates the pump when the water reaches the minimum and stops it when it reaches the maximum. 

The sensors can be simply stuck on with double sided tape (not included) and will read through the wall of the tank if there is water at that point. The reading can penetrate up to approx. 1cm and a wide range of non-metallic materials (glass, plastic, porcelain, PVC, etc.).

The operating cycle of this device is that when the low level sensor detects the absence of water, it activates the pump relay to start filling, when the high level relay detects that the water has reached that point, it disconnects the relay. 

The sensors must be mounted outside the tank, note that they are not waterproof. 

Specifications of Controller / Automatic Contactless Water Level Sensor for Tank (XKC-C352-2P)

• Power supply:  AC180V-250V,50/60Hz
• Consumption:  20-110 mAh
• Maximum power supported per relay output: 500W, use contactor to connect more powerful pumps. 
• Configurable NC/NO output
• Operating temperature: -10ºC to 75ºC
• Dimensions: 115x90x40
• Easy mounting with screws or DIN rail
• Power cable not included, mounting required
• Probe cable length: 1m

Content

• Controller XKC-C352-2P
• 2x Probes XKC-Y25-V