Digital Humidity Controller for Humidifier or Dehumidifier (SHT20)

Controlling the humidity of a room will be a piece of cake with this hygrostat, just check if our humidity level tends to go down or up to connect a humidifier (to raise humidity) or dehumidifier (to lower it) to its output.  

Configuration: 

• If you need to raise humidity, connect an humidifier to the output and press "up" button for 3 sec. to start set mode, then set an humidity level, automatically the hygrostat will activate your humidifier when the probe reads a level below the set value and will deactivate it when it exceeds that value. 

• If you need to decrease humidity, connect a dehumidifier to the output and press the "down" button for 3 sec. to start the setting mode, then set an humidity level, automatically the hygrostat will activate your dehumidifier when the probe reads a level above the set level and will deactivate it when it falls below that value. 

• Press and hold both buttons for 3 seconds to reset the device to factory settings. 

Specifications of Digital Humidity Controller for Humidifier or Dehumidifier (SHT20)

• Input power: 230V AC / 50HZ
• Max load: 1500W
• Humidity range: 0-100%
• Accuracy: 0.1% RH
• Installation required, AC plug not included. 
• Dimensions: 60x45x31mm

Content

• Digital Humidity Controller for Humidifier or Dehumidifier (SHT20)